AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Opensprinkler openhab8/3/2023 SW-reset via WebGUI seems not to be sufficient in order to apply the new configuration. With DIP switch 1.3 OFF only ident-data can be read ( i and report 1) but not the other reports as well as the commands needed for the write access.Īfter setting the DIP switch, you need to power OFF and ON the station. In order to enable the UDP port 7090 on the Keba station with full functionality, DIP switch 1.3 must be ON. UDP port 7090 needs to be available/free on the openHAB server. Number : Dimensionless KebaCurrentRange "Maximum supply current " Set an energy limit for an already running or the next charging sessionĪuthenticate and start a session using RFID tag+RFID classĬurrent offered to the vehicle via control pilot signalization RFID tag class used for the last charging session RFID tag used for the last charging session Total energy delivered since the last reset of the wallbox System uptime since the last reset of the wallbox Maximum current the wallbox can deliver, if network is lost Maximum current the charging station should deliver to the EV in %Īctive power delivered by the charging stationĮrror code state 1, if in error (see the KeContact FAQ)Įrror code state 2, if in error (see the KeContact FAQ) Maximum current the charging station should deliver to the EV in A # ChannelsĪll devices support the following channels: Channel ID Optionally, a refresh interval (in seconds) can be defined as parameter refreshInterval that defines the polling of values from the charging station. The Keba KeContact P20/30 requires the IP address as the configuration parameter ipAddress. Available services are n for programs, stations and controllers (for running once program), and opensprinkler.stop for stations or controller (to stop all stations). The Keba KeContact P20 and P30 stations which are providing the UDP interface (P20 LSA+ socket, P30 c-series and x-series) are supported by this binding, the thing type id is kecontact. Please use the n service to run programs. This binding integrates the Keba KeContact EV Charging Stations (opens new window).
0 Comments
Read More
Leave a Reply. |